Universal Throttle Cable Stainless Steel 24" fits Mopar Ford GM and More

Description

Home
Payment
Shipping
Return Policy
About Us
Contact Us
Feedback
Catalogue
Other
Fuel and Oil System
Suspension Parts
Heat/Flame protection
Car Electronic Parts
Exhaust Related
Engine Related
Wastegate
Belt Pulley
Engine Cover
Engine Accessories
Brakes
Short Shifter
Gauges/Gauge Sets
Accessories
Intercooler and piping
Steering Wheels
Lines and Fittings
Exterior Accessories
Car Interior Part
Universal Throttle Cable Stainless Steel 24" fits Mopar Ford GM and More
Application:
Fit for Carbureted, Select EFI Applications.
For 86-93 Ford Mustang 302 5.0L.
Vehicle compatibility charts are for REFERENCE ONLY. Check your vehicle with OEM below to match your needs.
Specification:
100% quality assurance tested, more responsive, less expensive, easier to install.
Feature a "U-Cut-to-Fit" outer housing and stainless inner wire.
Designed with a specially extruded liner for the extended life of the cable.
Equipped with aluminum fittings and aluminum ferrules to eliminate fraying.
Designed without cotter pins or set screws and adapt to factory and aftermarket pedals for an easy installation.
Material & Color:
Material: made of high quality Stainless Steel and Aluminum.
Color: as picture.
Package Included:
1x Throttle Cable;
1x Wrench. (100% Brand New Never Used Or Installed)
Installation Instructions:
Before beginning the installation, disconnect the negative battery cable and use wheel chocks to block the vehicle's wheels.
The hole in the firewall must line up with the hole in the upper arm on the Throttle Pedal. Determine exactly where the Throttle Cable needs to pass through the firewall.
Remove the carb end assembly. Pull the inner wire out of the cable housing.
Insert the firewall fitting through the firewall from the engine side.
Insert the throttle cable adjuster into the Cable Mounting Bracket. NOTE:There must be some slack to allow for engine movement.
Reinstall the inner wire into the cable housing from inside the passenger compartment. Connect the clevis (or the ball end if the clevis was removed) to the Throttle Pedal.
Attach the carb end assembly to the throttle arm. Tighten the nut.
Cut the inner wire off so that roughly 1" of the inner wire will remain inside the carb end assembly.
Insert the inner wire into the carb end assembly. Pull all the slack out of the inner wire and tighten the set screw in the carb end assembly.
Check for proper operation of the throttle (and Kickdown if equipped) and adjust as necessary. Make sure there is no binding in the throttle linkage and that the throttle returns to the closed position when the pedal is released.
Note:
Provide Tracking Number With Every Order, Please Buy With Confidence!
No installation guides are included, we highly recommend to seek professional installation. Any damage during installation will not be refunded.
Will come with everything you see in the picture. Please allow difference due to manual measurement.
Please check that the picture matches before purchase. The color of the actual items may slightly different from the listing images due to different computer screen, thanks for your understanding.
For any inquiries or special requests such as larger amount ordering please write to us.
Payment
Delivery details
Feedback
Contact us
Payment
Delivery details
Feedback
Contact us