Shifter shift control lever bushing cup for most Nissan RWD cars & trucks 16mm

Description

OE replacement plastic bushing cup for the shift control lever pivot ball on
manual transmission
shifters found in the following
Datsun / Nissan REAR WHEEL DRIVE
applications:
1975-1988 200SX
1989-1998 240SX
1972-1973 240Z
1974 260Z
1975-1978 280Z
1979-1983 280ZX - non-turbo only
1984-1989 300ZX - non-turbo only
Does NOT FIT turbo models
Does NOT FIT newer models
1974-1979 620 pickup
1980-1986 720 pickup
1986-1997 Hardbody pickup - I4 only
Does NOT FIT V6 models (20mm OD)
1998-2018 Frontier pickup - all
1987-1988 Pathfinder SUV - I4 only
Does NOT FIT V6 models (20mm OD)
2000-2004 Pathfinder SUV
2000-2015 Xterra SUV - all
Transmission models include F4W71 (B-on), FS5W71 (B-on), late FS5R30A & B (1998/2000-up trucks only), FS6R30A
Bushing has a
16mm outside diameter
and fits onto a 12mm dia sphere (at bottom of shift lever)
WARNING: early FS5R30 use a 20mm OD bushing - see separate listing
If yours is loose or missing (!) you need one of these!
Simple installation - remove shifter boots, remove snap ring inside housing, & lift out lever (no need to remove base)